Using A Web Browser - Micromeritics AccuPyc II 1340 Operator's Manual

AccuPyc II 1340

Using a Web Browser

Data results for the last five analyses are saved in the control module for each attached unit.
These results can be viewed by accessing a web browser.
To use this feature, you must be connected to a network via an ethernet cable and have a key-
board attached to a USB port.
These steps assume an IP address has already been assigned. If an address has not
been assigned, refer to
1. Make a note of the IP address:
a. Press
b. Press
prompt is displayed:
Unit[n]
Communications
IP Address?
DHCP
The fourth line may show Specify, depending on the manner in which the IP address
was assigned (refer to Communications, page
prompt).
c. Press
Unit[n]
Communications
Assigned Address:
(assigned address)
If the address was specified, the third line of the display shows IP Address? and the
fourth line shows the entered address. This line is editable since it is specified and not
assigned automatically. An assigned address cannot be edited.
d. Press
2. Access your web browser.
3. Enter your IP address in the Address field of the web browser.
This will consist of 12 numbers in the following format: nnn.nnn.nnn.nnn.
June 2013
Communications, page
to access Set Up.
Alt + 2
CHOICE until Communications is displayed, then press
SN1234 10 cm3
to view the assigned address:
ENTER
SN1234 10 cm3
to return to the Reload prompt.
Alt + CLEAR
3-18
for information on obtaining one.
ENTER
3-18 for additional information on this
Reviewing Data
. The following
4-9