Specifying System Options - Micromeritics AccuPyc II 1340 Operator's Manual

Installing the Analyzer
4. Run your index finger around the O-ring groove.
5. Replace the chamber cap; turn the cap clockwise to close it.

Specifying System Options

The pycnometer is shipped with system defaults as follows:
Option
Pressure units
Language
Date/Time
If you wish to accept these defaults, proceed to Calibrating the Pycnometer on the next page.
If you wish to change the defaults:
1. Press ALT + 2
Unit[n]
Set-up type?
Analysis parameters
2. Refer to
3. Edit the desired options, then press
prompt.
2-10
kPag, psig
English, French, German, Italian, Spanish
Set for Eastern Standard Time (EST), USA at time of shipment
to access the Set-up type prompt.
SN1234 10 cm3
X - O - X
Unit Types, page 3-22 for details on changing these options.
Choices
to save all changes and return to the Reload
SAVE
AccuPyc II 1340
Default
psig
English
June 2013