Micromeritics AccuPyc II 1340 Operator's Manual page 66

System Commands
Unit[n] SN1234 10 cm3
X - X - X
Which Chamber?
(chamber type)
Unit[n] SN1234 10 cm3
X - X - X
Start:
(HH:MM:SS) (DD/MM/YY)
Unit[n] SN1234 10 cm3
X - X - X
End:
(HH:MM:SS) (DD/MM/YY)
Unit[n] SN1234 10 cm3
X - X - X
Cell [n] = (volume)
Dev [n] = (deviation)
or
Unit[n] SN1234 10 cm3
X - X - X
Exp [n] = (volume)
Dev [n] = (deviation
3-32
Enables you to choose whether you wish to view calibration
data for the sample cell chamber or the expansion chamber.
Choices: Cell volume, Expansion volume
Press until the desired chamber is displayed, then
CHOICE
press .
ENTER
Displays the time and date the calibration began.
Press .
ENTER
Displays the time and date the calibration completed.
Press ENTER .
Displays the cell or expansion volume (depending on the
selection you made at the Which Chamber prompt), and
the deviation from the mean.
[n] shown in the prompts to the left represent the run num-
ber.
Press CHOICE if you wish to exclude the displayed density
(or volume) from the calculated average. This will place an
asterisk next to it indicating that it will not be included.
Press CHOICE again to remove the asterisk and have the
value again included in the average.
Each time you press CHOICE
value, a new deviation is calculated and displayed.
Press to view the values for the next cycle.
ENTER
Press when you wish to return to the Reload prompt.
SAVE
When you press , all collected data are recalculated
SAVE
automatically, and all data reduction messages are added
back into the queue.
AccuPyc II 1340
to exclude (or include) the
Aug 2013