Micromeritics AccuPyc II 1340 Operator's Manual page 30

Installing the Analyzer
4. Press ENTER
Unit[n]
Analysis Parameters
Number of Cycles:
10
5. Press
ENTER
Unit[n]
Analysis Parameters
Cycle Fill Pressure:
19.500 psig
6. Press
ENTER
Unit[n]
Analysis Parameters
P1, P2 end by?
Equilibrate
7. Press
ENTER
Unit[n]
Analysis Parameters
Equilibration Rate:
0.005 psig/min
8. Press
ENTER
Unit[n]
Analysis Parameters
Use Run Precision?
No
9. Press SAVE
2-12
; accept the default of 10 for the number of cycles.
SN1234 10 cm3
; accept the default cycle fill pressure of 19.500 psig.
SN1234 10 cm3
; accept the default of Equilibrate.
SN1234 10 cm3
; accept the default value of 0.005 psig/min.
SN1234 10 cm3
; accept the default.
SN1234 10 cm3
to save the values and return to the Reload prompt.
AccuPyc II 1340
June 2013