Micromeritics AccuPyc II 1340 Operator's Manual page 65

AccuPyc II 1340
Unit[n] SN1234 10 cm3
X - X - X
Dn [n] = (density)
Dv [n] = (deviation)
or
Unit[n] SN1234 10 cm3
X - X - X
V [n] = (volume)
Dv [n] = (deviation
Calibration
Press to review or edit calibration results; the following prompts display if they were selected
Alt + 5
for the calibration. You may edit the information in the prompts if desired
Unit[n] SN1234 10 cm3
X - X - X
Chamber insert?
(insert)
Unit[n] SN1234 10 cm3
X - X - X
Volume of Cal Std:
(volume)
Aug 2013
Displays the Density or Volume (depending on the selection
you made for Analysis display mode).
[n] shown in the prompts to the left represent the cycle num-
ber.
Press to exclude the displayed density (or volume)
CHOICE
from the calculated average. This will place an asterisk next
to it indicating that it has been excluded. Press
again to remove the asterisk and have it included.
Each time you press
CHOICE
value, a new deviation is calculated and displayed.
Press to view the values for the next cycle.
ENTER
Press when you wish to return to the Reload prompt.
SAVE
When you press , all collected data are recalculated
SAVE
automatically, and all data reduction messages are added
back into the queue.
Displays the insert you selected for the calibration or None
if an insert was not used. If the selection is incorrect, press
until the correct one is shown, then press
CHOICE
Choices: None, 0.1 cm
None, 3.5 cm
3
None, 35 cm
None, 650 cm
pycnometer)
Displays the volume of the calibration standard that was
used for the calibration.
Press .
ENTER
CHOICE
to exclude (or include) the
3 3
(for 1 cm pycnometer)
3 3 3
, 1.0 cm (for 10 cm pycnometer)
3 3
, 10 cm (for 100 cm pycnometer)
3 3
, 1300 cm (for 2000 cm
System Commands
.
ENTER
3
3-31