Micromeritics AccuPyc II 1340 Operator's Manual page 62

System Commands
Copy to USB Stick
Enables you to write a file containing the calibration information for the current unit to a USB stick.
Unit[n] SN1234 10 cm3
X - X - X
Calibration Type?
Copy to USB stick
Unit[n] SN1234 10 cm3
X - X - X
Insert USB stick
and press [ENTER]
Unit[n] SN1234 10 cm3
X - X - X
Calibration for
SN (nnnn) copied
Unit[n] SN1234 10 cm3
X - X - X
Remove USB stick
Load from USB Stick
Loads calibration information to the current unit.
Unit[n] SN1234 10 cm3
X - X - X
Calibration Type?
Load from USB stick
Unit[n] SN1234 10 cm3
X - X - X
Insert USB stick
and press [ENTER]
3-28
Press until the desired option is displayed:
CHOICE
Press ENTER .
Insert the USB device into the USB connector on the rear
panel of the unit.
Wait a few seconds, then press
These prompts appear in succession.
Remove the USB stick; the system automatically returns to
the Reload prompt.
Press until the desired option is displayed:
CHOICE
Press .
ENTER
Insert the USB device into the USB connector on the rear
panel of the unit.
Press .
ENTER
.
ENTER
AccuPyc II 1340
Aug 2013