Multivolume Inserts; Operating Parameters - Micromeritics AccuPyc II 1340 Operator's Manual

AccuPyc II 1340
The MultiVolume Insert option enables you to analyze samples using smaller-sized sample
chambers with your AccuPyc. MultiVolume Inserts are available as follows:
• AccuPyc 2000-cm
calibration standards. A tool is also included to allow removal of the supporting inserts.
• AccuPyc 100-cm
cups and appropriate calibration standards. A fritted filter lid, which prevents the escape
of sample particles under rapid gas flow, is included for the 10-cm
• AccuPyc 10-cm
cups and appropriate calibration standards. Fritted filter lids are included for both inserts.
• AccuPyc 1-cm
Refer to Ordering Information for the appropriate part number and ordering information.

Operating Parameters

Operating procedures using inserts typically are the same as when not using them. However,
you do have to request that a prompt display during the procedures allowing you to choose the
MultiVolume insert you are using. Perform the following steps to have a Chamber Insert
prompt display during standard operations.
1. Press
Alt + 2
2. Press
CHOICE
3. Continue pressing
4. Press CHOICE
Unit[n]
Report Options
Request insert?
Yes
5. Press
SAVE
A Chamber Insert prompt will display during all normal operating procedures, allowing you
to choose the appropriate insert. For example, a Chamber Insert prompt will display when
starting a calibration or analysis.
June 2013
J. MULTIVOLUME INSERTS
3
capacity; includes 650- and 1300 cm
3
capacity; includes 10- and 35-cm
3
capacity; includes 1- and 3.5-cm
3
capacity; includes a 0.1-cm
to access the Set Up function.
until Report Options is displayed, then press
Enter until the Request Insert prompt is displayed.
until Yes is displayed, then press
SN1234 10 cm3
to save the change(s) and return to the Reload prompt.
3
cups, supporting inserts and
3
inserts with corresponding sample
3
insert.
3
inserts with corresponding sample
3
insert/sample cup combination.
.
ENTER
ENTER .
Appendix J
J-1