Micromeritics AccuPyc II 1340 Operator's Manual page 44

System Commands
value (when applicable). To use the default value, just press
+ 2 , the following prompt is displayed:
To select Analysis Parameters, which is the default option, press
If you do not wish to use the default option, you can use the keypad to enter or choose other responses.
There are two types of prompts:
• Data entry prompts are followed by a colon (:). Use the keypad to enter the desired
value, then press
and a message showing the range is displayed; enter a value in the range displayed.
3-10
Unit[n] SN1234 10 cm3
X - X - X
Setup Type?
Analysis Parameters
. If you enter an value that is out of range, you will hear a beep
ENTER
ENTER . For example, when you press
.
ENTER
AccuPyc II 1340
Alt
Aug 2013