Micromeritics AccuPyc II 1340 Operator's Manual page 58

System Commands
Unit[n] SN1234 10 cm3
Analyze
Sample ID:
(user-entered)
Unit[n] SN1234 10 cm3
Analyze
Description Line 1
(user-entered)
Unit[n] SN1234 10 cm3
Analyze
Sample Mass:
(user-entered)
3-24
Enables you to enter a sample identification for the current
analysis.
You can enter up to 20 numbers and dashes; press
mal) to insert a dash. If you have a keyboard connected, you
can enter up to 20 alphanumeric characters.
Enter the sample ID and press
Enables you to enter a description for the current sample.
You can use up to 20 alphanumeric characters for each line.
These prompts are used when a keyboard is attached to the
pycnometer.
Enter the description and press
of the Description is displayed. Enter the description and
press
ENTER.
This prompt displays only when you select Density for
Analysis display mode (Anls display mode prompt); it does
not display if you choose Volume.
Enter a value for the sample mass, then press
Range: 000.0000 to 10000.0000 g
This field will also accept input from an analytical balance.
The analytical balance must be connected to the RS232 port.
While this prompt is displayed, press the appropriate button
on your analytical balance to transfer the mass; most
balances use the button (refer to the manufacturer's
Enter
manual for the appropriate command).
. (deci-
ENTER .
ENTER ; a prompt for Line 2
.
ENTER
AccuPyc II 1340
Aug 2013