Attach Sl Support To Ground Back - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 40: Attach SL Support to Ground Back
A: Loosely attach (1450) SL Support to (2342) Ground Back
using 1 (H2) 1/4 x 2" Hex Bolt (with flat washer, lock washer
and t-nut) in the top hole and 1 (S15) #8 x 1-3/4" Wood Screw
in the bottom hole. (fig. 40.1 and 40.2)
B: Insert (1450) SL Support into TNR2 Post Mount and
attach with 2 (PB2) 1/4 x 1-1/4" Pan Bolts (with lock washer
and t-nut). Keep these bolts loose. (fig. 40.2)
C: Use (1450) SL Support as a guide to judge the proper bolt
location, remove the bottom pan bolt and nut. The bolt will
no longer be needed, but keep the lock nut. (fig. 40.3)
D: Attach the top of the TNR2 Post Mount to TNR2 Slide
Clamp Ring using 1 (PB2) 1/4 x 1-1/4" Pan Bolt (with the
previously removed lock nut). (fig. 40.4)
E: Tighten all the bolts and the screw from this step.
Remove PB1 (1/4 x 3/4"
Pan Bolt first then install
PB2 (1/4 x 1-1/4" Pan Bolt
with previously removed
lock nut)
Wood Parts
1 x SL Support 2 x 4 x 26-1/4"
1450
Fig. 40.3
Fig. 40.4
TNR2 Post
Mount
1/4" Lock Nut
1450
Hardware
1 x #8 x 1-3/4" Wood Screw
S15
3 x 1/4 x 1-1/4" Pan Bolt
PB2
2 - (1/4" lock washer & 1/4" t-nut)
1 - (1/4" lock nut - previously removed)
1 x 1/4 x 2" Hex Bolt
H2
(1/4" flat washer, 1/4" lock washer, 1/4" t-nut)
93
PB2
1/4" Lock
Washer
Fig. 40.2
1450
1/4" T-Nut
PB2
Fig. 40.1
TNR2 Post
Mount
1/4" T-Nut
1/4" Flat
Washer
1/4" Lock
Washer
2342
H2
S15
Other Parts
1 x TNR2 Post Mount