Dormer Assembly - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 7: Dormer Assembly
Part 1
A: Place 1 (2347) Roof Block on (2348) Roof Board A with angled edges facing up. Edge of (2347) Roof Block to
be flush with bevelled edge of (2348) Roof Board A. Attach boards together with 1 (S2) #8 x 1-1/2" Wood Screw at
bevelled edge side. Do not add a screw on the opposite end until Step C. (fig. 7.1 and 7.2)
B: Place 1 (2347) Roof Block on (2349) Roof Board B with angled edges facing up. Edge of (2347) Roof Block to
be flush with bevelled edge of (2349) Roof Board B. Attach boards together with 2 (S2) #8 x 1-1/2" Wood Screws.
(fig. 7.3 and 7.4)
C: Place both assemblies together, as shown in fig. 7.5, then pre-drill pilot hole using a 1/8" drill bit and install 1
(S3) #8 x 2-1/2" Wood Screw through (2348) Roof Board A into both (2347) Roof Blocks. (fig. 7.5)
Fig. 7.1
Side View
Do not add
screw yet
Fig. 7.3
Side View
2349
2347
Flush to
Bevelled
Edge
Wood Parts
1 x Roof Board A 1 x 5 x 15-5/8"
2348
1 x Roof Board B 1 x 5 x 15"
2349
2 x Roof Block 2 x 2 x 14-3/4"
2347
2348
2347
S2
Flush to
Bevelled
Edge
S2
2349
S3
Flush to
Bevelled
2347
Edge
Fig. 7.2
2347
Hardware
3 x #8 x 1-1/2" Wood Screw
S2
1 x #8 x 2-1/2" Wood Screw
S3
27
2348
Fig. 7.4
2349
Fig. 7.5
Leave gap here
2347
2348