Attach Swing Assembly To Fort - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 31: Attach Swing Assembly to Fort
A: Attach Swing Assembly from Step 5 to (2194) SW Mount with 1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock washer,
flat washer and t-nut) and 1 (G8) 5/16 x 2" Hex Bolt (with 2 flat washers and 1 lock nut) as shown in fig. 31.1 and
31.2.
B: Drive 1 (0318) Ground Stake 10-1/2" into the ground at each (1863) SW Post on the outside of the assembly
and attach with 2 (S3) #8 x 2-1/2" Wood Screws per ground stake. (fig. 31.2 and 31.3)
5/16"
T- Nut
5/16"
Lock nut
5/16"
Flat
Washer
Fig. 31.3
S3
0318
Wood Parts
2 x Ground Stake 1-1/4 x 1-1/2 x 14"
0318
WARNING:
To prevent tipping and avoid potential injury,
stakes must be driven 10-1/2" into ground. Digging or driving
stakes can be dangerous if you do not check first for under-
ground wiring, cables or gas lines.
Fig. 31.2
G8
1863
10-1/2" Into Ground
2194
5/16" Flat
Washer
5/16" Lock
Washer
G5
Hardware
4 x #8 x 2-1/2" Wood Screw
S3
1 x 5/16 x 4-1/2" Hex Bolt
G5
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
1 x 5/16 x 2" Hex Bolt
G8
(5/16" flat washer x 2, 5/16" lock nut)
81
Fig. 31.1
1863