Startup Prompting Sequence - DANIEL 2234 Manual

__________________________ MODEL 2234 DIGITAL FLOW COMPUTER
Apply power to the computer to confirm if the Startup Prompting Sequence has
been previously completed. READY indicates that the Startup Prompting Sequence
has already been completed and the computer is ready for operation.
CNFIG indicates that the Startup Prompting Sequence has not been performed.
Slide the computer out of the case to the detent position. Set the internal operator
entry "enable/disable" switch on PC Board No.1 to the "enable" position. Confirm
that the green "enable" lamp on the front panel is lighted. Refer to paragraph 2.6.2
for assistance in performing the Startup Prompting Sequence.

2.6.2 STARTUP PROMPTING SEQUENCE

In the sequence that follows, the mnemonics used by the computer to request data
are shown in capital letters. The data required by the computer is entered simply
by keying in the required numbers via the front panel keyboard and then pressing
the ENTR key. The computer will display OK if the number entered is acceptable.
The computer then steps to the mnemonic for the next parameter that is required.
If the data entered is improper, the computer will request the parameter again. For
ease of data entry, complete the form provided in Table 2-1a of this manual and
use it as a guide when performing the startup.
A "power-save" feature of the computer causes the display of data or a mnemonic
to be replaced by a blinking asterisk (*) one minute after the last operator entry.
The data or mnemonic is recalled to the display by pressing DSPY (display).
SECTION 2
26