Table of Contents
Advertisement
__________________________ MODEL 2234 DIGITAL FLOW COMPUTER
Key on "0" to note and to clear alarms and the alarm memory list. Press and
release the CMD key. Note the alarm number on the computer display. Press the
CLR key. The alarm is cleared by the computer and the next alarm number is
displayed. Continue to clear each alarm until the computer displays READY.
If the alarm numbers begin to repeat, the condition(s) causing the alarm(s) still
exists and must be eliminated. Refer to Error Code Diagnostic Table 2-5 to
determine the possible cause of the alarm and suggested solutions.
After all alarm and alarm memory conditions are cleared, both the red and amber
indicators will go out. The display will indicate READY.
Paragraph 3.5.1 of this manual describes the basic use of operator-entered
parameter values and how to enter the values into the computer. Paragraph 3.6
describes the values individually and their acceptable entry limits.
SECTION 2
32
Advertisement
Table of Contents
