DANIEL 2234 Manual page 43

MODEL 2234 DIGITAL FLOW COMPUTER ___________________________
T. PA
n
(PA1, PA2, etc.).
U. PT - Enter Plate Measurement Temperature (DEGF) for the respective
n
plates (PT1, PT2, etc.).
V. LA
n
(LA1, LA2, etc.).
W. LT
n
respective lines (LT1, LT2, etc.).
N through W are repeated in succession for each line. After the Startup Prompting
Sequence is completed (all of the data required is entered), the computer will
display READY to indicate that it can begin flow calculations. However, during
initial startup, several alarm conditions will necessarily have occurred since the
computer previously has not been programmed.
The red lamp indicator on the computer's control panel indicates an existing alarm
condition. The amber light indicator signifies an alarm condition that occurred in
the past and has not been acknowledged and cleared by the operator.
SECTION 2
- Enter the Plate Expansion Coefficient for the respective plates
- Enter the Pipe Expansion Coefficient for the respective lines
- Enter the Pipe Measurement Temperature (DEGF) for the
31