DANIEL 2234 Manual page 42

__________________________ MODEL 2234 DIGITAL FLOW COMPUTER
N. LF
n
used.
O. LK
n
Factor of the line (n) indicated by the display. Acceptable values are -
9 to +9. Refer to paragraph 2.6.3.1 for detailed instructions. Pressing
ENTR enters 0 for LK
P. HF
n
measured differential pressure in the indicated transducer (HF1, HF2,
etc).
_______________________________________________________
NOTE:
_______________________________________________________
Q. IDn - Inch - Enter the orifice diameter for the respective line (ID1,
ID2, etc.).
R. OD
n
(OD1, OD2, etc.) in inches.
S. TL
N
TL2, etc.).
TL
N
Code Number
1
2
30
- Enter line (n) cutoff in inches of water (InH2O) for each line
- Enter the numerical value of the integer for the Totalizing
- H20 - Enter the full scale value, in inches of water, for
See Field Wiring Diagram for definition of transducers
relative to configuration selected.
- INCH - Enter the orifice diameter of the respective meter tube
- Enter the pressure tap location for the respective line (TL1,
.
n
Tap Location
(from the orifice)
Upstream
Downstream
SECTION 2