Case Mounting; Access To Plug-In Printed Circuit Boards - DANIEL 2234 Manual

__________________________ MODEL 2234 DIGITAL FLOW COMPUTER

2.5.2 CASE MOUNTING

The Model 2234 Flow Computer is designed primarily to be mounted in an
industrial panel cutout. The case is held in place in the panel by jack bars
provided with the computer. The panel mounting bezel is provided to cover
unfilled space around the computer's front panel after installation and may or may
not be used. See Drawing CE-9117 in the back of this manual.

2.5.3 ACCESS TO PLUG-IN PRINTED CIRCUIT BOARDS

Access is gained to the plug-in printed circuit boards by pressing the latch release
on the front of the computer and sliding the computer out of the case to the detent
position. The "Enable/Disable" switch is located towards the left top-rear of P.C.
Board No.1. This allows access to test points, etc. necessary to perform a bench
calibration as discussed in Section 4. Turn off power if the computer is to be
removed from the case. The power switch is located on the power supply at the
rear of the case. Remove the computer from the case by pressing the latch release
on top of the computer, pulling it out of the case, and disconnecting the cable at
the rear of the computer.
SECTION 2
20