Parameter Display Actions - DANIEL 2234 Manual

MODEL 2234 DIGITAL FLOW COMPUTER ___________________________

3.7.3 PARAMETER DISPLAY ACTIONS

The parameter display Command Codes used to display the values of parameters
set into the computer during initial startup.
A. Display Configuration - Command Code 5
The type configuration entered by the operator during initial startup may be
displayed with the use of Command Code 5. The display of the configuration
appears as shown below when Command Code 5 is entered into the computer.
CONFIG
then
CFG y z
where:
x
y
z
SECTION 3
= Density type (DENTYP) selected
DENST A for analog densitometer
API 2565 for API calculated
DENST Fw for frequency densitometer input
(w = Level 1, 2, or 3)
= Number of meter tubes and their stack
configuration
= Tap Type being used
FT for Flange Tap
103