Startup And Application Download - DANIEL 2500 User's Reference Manual

MODEL 2500_______________________________________________________ MODEL 2500_______________________________________________________

STARTUP AND APPLICATION DOWNLOAD

After the DANIEL INDUSTRIES MODEL 2500 INSTRUMENTATION SYSTEM
has been mechanically and electrically installed, startup and application download
procedures can begin. For instructions, refer to Daniel Industries Manual, P/N 3-
9000-590.
Unless the MODEL 2500 has been supplied with a resident program at the factory,
there must be a computer available (IBM PC or equivalent), which is connected to
the communications port on the Model 2500. If the MODEL 2500 has been
supplied with a resident program at the factory, a computer (IBM PC or equivalent)
will not be necessary.
Your software is delivered on 360 KB diskette(s) or on 3.5" diskette(s) archived
in a compressed format which cannot be directly executed until properly installed.
In most cases the installed software on the hard disk will be the working copy and
the distribution diskette will serve as a backup. The following instructions enable
you to install your software on a hard drive or on another diskette.
a. Insert the distribution diskette in drive A and type:
A:
b. A:\>INSTALL
c. Follow the instructions on your screen.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
SECTION 3 3 SECTION
< <ENTER>
< <ENTER>
13