Calibration, Axis 1, Irb 7600 (Early Design) - ABB Levelmeter 2000 Instructions Manual

3 Calibration

3.7. Calibration, axis 1, IRB 7600 (early design)

3.7. Calibration, axis 1, IRB 7600 (early design)
General
This section details how to perform the mechanical calibration of axis 1 using special
calibration equipment without sensors.
The IRB 7600 robot has two different designs of the calibration tabs on the base. This section
details how to calibrate axis 1 when the robot has the earlier design of the tabs.
Required equipment
Equipment
Calibration tool
Calibration tool position, early design
The calibration tool is positioned at the base of the robot, as shown in the figure below. This
figure shows the early design of the calibration tabs.
xx0200000090
A
B
C
48
Art. no.
3HAC 13908-4
Calibration tool
Calibration tab, base, early design
Calibration tab, frame, early design
Note
3HAC 022907-001 Revision: -