ABB Levelmeter 2000 Instructions Manual page 24

2 Reference information
2.5. Initialization of Levelmeter 2000
Select filter type
Step
Measuring units
Step
Installation of sensor
Step
Result
The Levelmeter 2000 is now initialized and ready for service.
22
Action
1. Press ON/MODE until the dot flashes under
FILTER .
2. Press ENTER.
3. The standard filter type no. 5 flashes.
4. If type 5 does not flash, press ZERO/SELECT to
select filter type 5 and press ENTER.
Action
1. Press ON/MODE until the dot flashes under
UNIT .
2. Press ENTER.
3. Press ZERO/SELECT until mm/m flashes.
Two decimals (0.00) are shown on the display
4. Press ENTER.
Action
1. Connect the sensor to the Sensor connection
point.
2. Press ON/MODE .
3. Press ON/MODE until the dot flashes under
SENSOR .
4. Press ENTER.
5. Press ZERO/SELECT until a flashing "A" is
shown.
6. Press ENTER.
Wait until the "A" flashes again.
7. Press ENTER.
Info/Illustration
Shown in the figure Illustration,
Levelmeter 2000 on page 21!
Default setting is filter type 5.
Info/Illustration
Shown in the figure Illustration,
Levelmeter 2000 on page 21!
Info/Illustration
Shown in the figure Illustration,
Levelmeter 2000 on page 21!
3HAC 022907-001 Revision: -