Aerotech XR3 Hardware Manual page 19

XR3 Hardware Manual
Cooling Options
-C0
-C1
-C2
Mounting Options
-MT0
-MT1
Line Cord Options
-LC0
-LC1
-LC2
-LC3
-LC4
-LC5
-LC6
-LC7
PSO
-PSO1
-PSO2
-PSO3
-PSO5
-PSO6
Internal Shunt
-SI0
-SI1
-SI2
-SI3
Version
-DEFAULT
-LEGACY
www.aerotech.com
Built-in fan pulls cooling air from left side through the amplifier compartment
No cooling fan. External cooling through vented covers is required.
1U-high fan tray for cooling
Rack-mounted configuration
Rack-mounted configuration with drawer slides
No line cord
U.S. 115 VAC line cord
U.S. 230 VAC line cord
German compatible line cord
U.K. compatible line cord
Israel compatible line cord
India compatible line cord
Australia compatible line cord
One-axis PSO firing
Two-axis PSO firing
Three-axis PSO firing
Two-axis part-speed PSO firing
Three-axis part-speed PSO firing
No internal shunt
Internal shunt for first bus
Internal shunt for second bus
Internal shunt for first and second bus
Firmware Matches Software Line
Legacy Firmware Version X.XX.XXX
Chapter 1: Introduction
Section 2.13.
Section 1.2.
Section 2.5.
Section 2.2.4.
19