Checking The Brake Lining - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

Figure 17. Measuring wear on the suspension bracket (option)
Table 3. Wear dimensions of the suspension bracket (option)
Frame size
05
10
7.4.2

Checking the brake lining

1. If a load is attached to the hook, remove the load.
2. Disconnect the chain hoist from the main power supply network.
3. Remove the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
4. Check the main brake.
To check the brake lining of the main brake, locate the brake check hole in the brake
assembly.
5. Measure the depth of the gap in the brake check hole with a caliper.
6. Compare the measured brake wear value with the maximum allowed value for brake wear.
You can find the maximum value for the brake wear in the brake data sticker on the brake.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
W
Short [DIM mm]
Nominal DIM Min. DIM W
21.50 19.00
-
Bracket type
Long [DIM mm]
Nominal DIM
21.50
- 26.00
7 MAINTENANCE
Min. DIM W
19.00
23.00
6/2020