Replacing The Single Brake - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

The brake wear value varies according to the brake manufacturer and brake series.
For each brake type, the maximum value for the wear is indicated on the brake data
NOTE
sticker on the brake.
Do not exceed the maximum value for the brake wear.
7. If the brake has worn more than the maximum allowed criteria, replace the brake.
8. Check the secondary brake.
If the hoist has a double brake, the brake assembly includes also a secondary brake. The
secondary brake (2) is the brake that is on the top in the double brake assembly.
The secondary brake is a holding brake that works as a back-up brake for the main brake
(1). The secondary brake is the functional brake only, if the main brake is damaged and not
able to hold the load.
1
If the main brake operates normally, you do not need to check the wear on the
NOTE
secondary brake.
7.4.3

Replacing the single brake

1. If a load is attached to the hook, remove it.
2. Disconnect the chain hoist from the main power supply network.
3. Remove the end cover on the brake side.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
IQ BFK457-06
COMPACT
190V DC 20W
Nr: 13319905 2.8NM
IQ BFK457-06
COMPACT
190V DC 20W
Nr: 13319905 2.8NM
2
DD.MM.YY
max@ 20°C ;
xx.x mm
DD.MM.YY
max@ 20°C ;
xx.x mm
OWNER'S MANUAL
6/2020