Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual page 85

7. Remove the brake carefully.
8. Install the new brake on the shaft.
Secure the fixation with the three screws.
9. Plug in the brake cable (1).
10. Install the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
11. Tighten the screws of the end cover to the correct tightening torque.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
1
OWNER'S MANUAL
6/2020