Daily Inspections; Monthly Inspections - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

• Gearbox frame, sealing, bearing, gears, and oil or grease
• Hook block, coupling, connection pins
• Brake
The small parts (such as screws and washers) to be replaced during maintenance and
assembly work are not listed separately. The general overhaul carried out by the manufacturer
or an authorized specialist company fulfills the condition for continued operation of the chain
hoist.
Thus the relevant accident prevention regulations and the BGV D8 (VBG 8) are complied with.
Further utilization is approved when an expert engineer has entered the conditions for further
utilization into the test and inspection booklet. Completion of the general overhaul must be
confirmed in the test and inspection booklet and a further period of utilization in accordance with
FEM 9.755 must be entered.
Action
Check the function of the
emergency stop device.
Check the direction of
movements.
Check the chain lubrication.
Check the function of the limit
switches.
Check the control cable and
controller housing for damage.
Check the operation of the brake. Testing the hoist without load
Check the hook and the hook
safety latch.
1)
To be checked on a monthly level.
7.3.3

Daily inspections

The daily inspection items are listed in the chapter Checks before operating. Usually, these
checks are performed by the operator.
7.3.4

Monthly inspections

The monthly inspection items include the same check-ups as the daily inspections (see chapter
Checks before operating). The monthly inspections also include the following inspections:
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
Chapter(s)
Checking the operation with the
emergency stop button pushed
down
Testing the hoist without load
Lubrication
Testing the hoist without load
Checking the hoist before every
working shift
Checking the hoist before every
working shift, Measuring wear on
the hook
7 MAINTENANCE
Before Before each
1st run work shift
X
X
X X
X
X
X
X
Annual
inspection
1)
X
X
6/2020