Movements; Controls For Movements; Motor Control Methods - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

6.2

Movements

6.2.1

Controls for movements

The speed corresponds to the position of the direction control. The equipment moves at the
slowest speed when the push button is partially pressed and at the maximum speed when the
push button is fully pressed. The equipment stops moving when the push button is released.
When the push button is released, the
1
equipment stops moving.
When the push button is partially
2 pressed, the equipment moves at a
slow speed.
When the push button is fully
3 pressed, the equipment accelerates
up to the maximum speed.
If you press a push button (for example hoist UP) while the opposite direction push
NOTE
button is pressed (for example hoist DOWN), the lifting device does not change direction.
Sudden speed changes increase wear on motors and brakes and can cause an
NOTE
overtemperature in the motors.
6.2.2

Motor control methods

Two-speed push button control
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
OWNER'S MANUAL
6/2020