Fitting The Chain Bucket - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

Always follow the instructions that are provided by the lifting device manufacturer and
NOTE
the local authorities. The manufacturer of the hoist is not responsible for lifting
accessories that are provided by other manufacturers.
WARNING! FALLING LOAD HAZARD
Overloading can damage the auxiliary lifting devices. If the device fails, the load could
fall and cause serious injury or death.
Only use lifting devices that display clearly the rated capacity and that are approved by
the authorities.
Never attempt to lift a load before ensuring that it weighs less than the maximum
permitted load of the auxiliary lifting device.
Lifting points on the hoist
Lift the chain hoist from the suspension bracket. If lifting points are available on the product,
they are marked with a sticker.
NOTE Before lifting the chain hoist, read the instructions in chapter Lifting the hoist.
Figure 11. Lifting the chain hoist
4.4

Fitting the chain bucket

1. Attach the chain bucket (1) to the connection part (2) with the screw-lock carabiners (3).
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
OWNER'S MANUAL
6/2020