Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual page 93

7. Pull the brake cables carefully out on the
brake side.
The brake cables are led through the
hoist frame from the brake side to the
motor side. Pay attention to how the
brake cables are led through the hoist
NOTE
frame. When you have installed the new
brake, you must lead the brake cables
again from the brake side back to the
motor side.
8. Check that the brake data of the
replacement brake matches with the data
of the original brake.
You can find the brake data in the sticker
that is attached to the brake.
9. Remove the three screws that hold the
brake in place.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
OWNER'S MANUAL
6/2020