Adjusting The Lower Hook Position - Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual

4.10

Adjusting the lower hook position

When you determine the hook path or lifting height, ensure that the lower hook touches the
ground in the lower hook position. Secure the limit stop to the fifth chain link at the unloaded
end of the chain.
To reduce the lifting height, proceed as follows.
1. Drive the hook down to ground level so that the chain is slack.
2. Stop the chain hoist and activate the emergency stop or the main isolation switch.
Secure the emergency stop or main isolation switch against switching on again.
3. Remove the chain bucket. For more information, see chapter Removing the chain bucket.
4. Remove the limit stop on the chain bucket end of the chain.
5. Attach the limit stop directly behind the buffer.
The unloaded chain fall behind the limit stop must consist of at least five chain links.
6. Place the chain in the chain bucket. Attach the chain bucket to the hoist. For more
information, see chapter Fitting the chain bucket.
7. Turn on the power to the hoist.
8. Check the adjustment of the lower hook position by moving the hook.
9. Run the chain once through over the entire adjusted hook path.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
4 INSTALLATION
6/2020