Verlinde STAGEMAKER SL5 504 M2 B D8+ Owner's Manual page 91

8. Assemble the new double brake.
Pay attention to the orientation of the
NOTE
brake lining.
9. Install the new brake on the shaft.
1.
2.
3.
There may be two extra screws on the
brake. The screws are used during
transportation to keep the brake
NOTE
components together. Remove these
two screws when you have installed the
new double brake.
The top brake is the main brake, and the
NOTE
bottom brake is the secondary brake.
10. Plug in the brake cables (1) and (2).
11. Install the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
12. Tighten the screws of the end cover to the correct tightening torque.
For more information, see chapter Tightening torques for the chain hoist.
13. Turn on the power to the hoist.
14. Check that the brake works normally.
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
Secure the fixation with the three
screws. Pre-tighten the screws by
hand.
Tighten the screws with a tool.
If the brake has two more screws,
remove the screws.
2
1
1. Main brake
OWNER'S MANUAL
2. Secondary brake
6/2020