Setting The Low Flow Rate Cutting - Fuji Electric Time Delta-C FSV-2 Instruction Manual

4.9.6. Setting the low flow rate cutting

Description
 The output can be cut when the flow rate is too small.
 Effective for indication, analog output (4-20mA) and total operation.
Settable range: 0 to 5 [m/s] in terms of flow velocity.
(Factory set: 0.150 [m
Note 1) As required, set the low flow rate cut because the flow meter may read a
flow rate when the fluid in the piping is moving on account of convection,
etc. even if the valves are closed.
Note 2) The flow rate unit is as selected by "FLOW UNIT" in "MEASURE SETUP".
(See 4.8.2.)
For actual keying, refer to the typical operation indicated below. Set the protection to
OFF beforehand. (See Section 4.4.1.)
Operation Set the low flow rate cut point to 0.5 [m
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Set "0.5" by the
▼
Press the
ENT
▼
▼
▼
▼
Press the
ESC
the measurement mode.
3
/h])
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key twice to display "CUT OFF".
key once to blink the cursor.
ENT
key and the key.
key once to register.
ENT
――― CUT OFF has been registered. ―――
key once and then press the
ESC
3
/h].
key for 3 times to enter
-46-
Output
Low flow cut setting value
Display
OUTPUT SETUP
ZERO ADJUSTMENT
SET ZERO
CUT OFF
0.150
CUT OFF
0000.150
0000.150
0000.550
0000.550
CUT OFF
0000.500
CUT OFF
 COMPLETE 
↓
CUT OFF
0.500 m3/h
0.000 %
0.000 m3
Flow rate
m3/h
m3/h
m3/h
m3/h
m3/h
m3/h