How To Set The Flow Rate Unit - Fuji Electric Time Delta-C FSV-2 Instruction Manual

4.8.2. How to set the flow rate unit

Description
 Select the unit of flow rate.
 Metric system
Flow rate ········ L/s, L/min, L/h, L/d, kL/d, ML/d, m
kBBL/d, MBBL/d
<Note> First, set the unit system (metric) according to Section 4.8.1.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set a flow rate unit to "L/min".
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
▼
▼
▼
Press the
ESC
measurement mode.
3
/s, m
Description
key for 3 times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key once to display "FLOW UNIT".
key once to blink the cursor.
ENT
key several times to display "L/min".
key once to register.
ENT
――― "L/min" has been registered. ―――
key once and the key twice to return to the
ESC
3 3 3
/min, m /h (factory set), m /d, km
-31-
3 3
/d, Mm /d, BBL/s, BBL/min, BBL/h, BBL/d,
Display
MEASURE SETUP
SYSTEM UNIT
FLOW UNIT
FLOW UNIT
FLOW UNIT
FLOW UNIT
 COMPLETE 
↓
FLOW UNIT
0.000 m/s
0.000 L/min
METRIC
m3/h
m3/h
L/min
L/min