Install Device Front Panel - Elitech FreezePoint 6000 Series User Manual

Section 8: Servicing

8.4 Install device front panel

Figure 134 Install device front panel
Figure 135 Elevator cover with correct cable routing
1- Cable
2- Cable guide on thermistor probe
CAUTION!
Risk of cable break!
Figure 136 Tighten mounting screws
1. Install device front panel on device and push into place.
2. Pull out printer from device using handle. (Model 6000P/Model 6000SP
only)
3. Install printer cover on printer and push down. (Model 6000P/Model 6000SP
only)
The printer cover is now secured.
4. Push printer back into device. (Model 6000P/Model 6000SP only)
5. Route cables on thermistor probe through cable guide (2) and install
elevator cover on device.
Pay attention to correct cable routing.
6. Bolt elevator cover to elevator using the 2 mounting screws (1).
The device front panel is now installed.
CAUTION!
Do not leave elevator cover up when raising the elevator. Doing so can
cause risk of instrument damage
Correct cable routing
Incorrect cable routing
94