Clean Cooling Clamp; Replace Printer Paper (Models 6000P / 6000Sp Only) - Elitech FreezePoint 6000 Series User Manual

Section 7: Troubleshooting

Clean cooling clamp

Personnel: Service technician
Safety gear:
• Disposable lab gloves
Materials:
• Fine sandpaper
Figure 113 Clean cooling clamp

Replace printer paper (Models 6000P / 6000SP only)

Personnel: User
Safety gear:
• Disposable lab gloves
Materials:
• 1 Paper roll
Figure 114 Printer (pulled out)
Figure 115 Pull out printer
1. Power down device on rear side using on/off switch.
2. Remove device front panel (
3. Clean cooling clamp (1) on lower cooling system using sandpaper.
4. Install device front panel (
1. Power down device on rear side using on/off switch.
1-Paper roll
2-Ribbon
2. Pull out printer.
"Remove device front panel" on page 92).
"8.4 Install device front panel" on page 95).
84