Section 5: Setup
Personnel: Lab supervisor
1. Complete all activities for installation and connection of the device.
2. Verify that the connections at the rear side of the device are secure.
3. Check the elevator for ease of movement.
If necessary, grease the elevator guide (
4. Power up device on rear side using on/off switch.
5.1 Check printer (Models 6000P/SP)
Figure 22 Pull out printer
Figure 23 Paper roll feed direction
"8.5 Lubricate elevator" on page 96).
5. Device does not ship with paper installed in the printer. On initial set-up see
"Replace printer paper (Models 6000P / 6000SP only)" on page 84 for
instructions on installing paper roll.
6. Check feed direction of paper roll. Open printer by pulling on silver knob
(magnetic latch).
7. Compare feed direction of paper roll with feed direction shown.
43