Elitech FreezePoint 6000 Series User Manual page 72

Section 7: Troubleshooting
Figure 76 Remove initiation needle
Figure 77 Initiation needle components
Figure 78 Straighten initiation needle
4. Remove initiation needle from motor disk. Hold washer (1) of mounting
screw in place.
NOTE!
Loose washer between initiation needle and motor disk!
5. Remove guide tube (1) and fasteners (3) of initiation needle (2).
6. Make sure that the new initiation needle is as straight as possible (1&2).
1-Incorrect orientation
2-Correct orientation
If necessary, bend initiation needle so it is straight (3).
7. Shorten initiation needle to correct length. Proceed as follows.
72