Elitech FreezePoint 6000 Series User Manual page 85

Section 7: Troubleshooting
Figure 116 Turn knurled screw
Figure 117 Install Paper Roll
Figure 118 Activate paper feed
Figure 119 Paper feed
3. Turn knurled screw (1) counter-clockwise.
4. Remove empty paper roll from holder and dispose.
5. Cut off beginning of new paper roll and push onto holder.
Pay attention to correct feed direction of paper.
6. Position knurled screw and tighten by turning clockwise.
7. Power up device on rear side using on/off switch.
8. On the Start menu, select Settings
Tap Paper Feed.
The paper feed of the printer is activated briefly. (Fig. 121).
Tap Back to exit the menu.
9. Replace printer cover and push printer into casing.
Printer.
85