5.5.7.11 Remote Control - Power One AURORA PVI-OUTD-US Series Installation And Operator's Manual

Installation and Operator's Manual Page 77 of 108
(PVI-3.0/3.6/4.2-OUTD-x-US Rev: 2.1)
An arrow on left side of the display highlights your current selection. When the chosen
item is selected, press ENTER to confirm activation of the chosen mode.
PRODUCTION: Relay is only activated when inverter is connected to the grid
(contact closing across terminals "N.O." and "C")
FAULT: triggers relay activation (contact closing across terminals "N.O." and "C"),
only when an error signal occurs, i.e. when grid is disconnected, excluding Input
Under Voltage.
Fig. 22 - Alarm Contacts Terminal Block

5.5.7.11 Remote Control

This function is used to disable the inverter manual switch-off. Operation is as
follows:
- set to ENABLE to activate manual ON/OFF function
- set to DISABLE to disable manual ON/OFF function, so that Aurora operation will
only depend on external solar radiation.
Remote ON/OFF Remote ON/OFF
Enable Disable
Manual ON and OFF input is read on inverter digital input. When set to OFF, the
display will cycle through the following screens:
Remote OFF Waiting Rem.ON...
....to restart