Croplands WEED-IT Quadro User Manual page 74

Alarm
This menu indicates temperature and humidity tolerances accepted in the sensor. It is
designed to track sensors with problems (e.g. cracked window) in an early stage to prevent
excessive damage on the electronics.
Humidity +- refers to the relative humidity inside a sensor compared to the average of all
sensors.
Humidity + is the maximum accepted relative humidity in each individual sensor.
Humidity +- ____________________
Humidity+ ____________________
Temperature+ ____________________
12.2.4 Menu 205 Sensor settings
Configure the menu 205 position of each sensor; Configure the track for the whole system.
Margin ___________
Track ___________
Fluid ___________
For offset per sensor, see below.
74 / 82 | WEED-IT Quadro | User Manual - BT-UMWEEDQ-B
(same for each sensor, 'Preset' is indicated if 4
margin presets are enabled')
(make sure you press OK for 2 seconds to confirm
for all sensors)
(make sure you press OK for 2 seconds to confirm
for all sensors)