Croplands WEED-IT Quadro User Manual page 61

Sensor missing A sensor that was previously
there, is now missing
No sensors No sensors have been found
Direction arrow The speed sensors are faulty, or
in main screen the speed sensors are not
does not point correctly configured.
upwards while I
drive on a
straight track.
Direction arrow
wiggles while
I drive on a
straight track
If this occurs after a sensor
replacement, your supplier will
need to confirm this message and
set up the new sensor.
If this problem occurs without
changing the sensors this indicates
a communication problem
between one of the sensors and
the Control unit. Follow the same
procedure as you would in case of
a COM error. The sensor with the
communication issue can be hard
to track down. Browse through the
sensor screens in menu 100 and
check sensor firmware version and
status for any anomalies.
Check the Control unit connection
cables (between the Power
converter and the Control unit) for
physical damage.
Check the Power converter for any
damage. Open the lid and check
for any signs of short circuits or
moisture inside.
Contact your supplier immediately
and report any findings.
Check functioning of the speed
sensors.
A LED light on the back of the
sensor should flash on and off in a
regular pattern when driving at a
fixed speed (indicating detection
pulses). Check this on both
sensors separately. Be careful
when performing this check.
Always have at least one other
person present to properly
perform this check.
If the LED lights do not flash, the
sensor is faulty. Contact your
supplier.
WEED-IT Quadro | User Manual - BT-UMWEEDQ-B | 61 / 82