Safety - Electrical Installation - Croplands WEED-IT Quadro User Manual

2.2.4 Safety - electrical installation

Only use approved fuses. Fuses that are too large may cause a system
overload; this increases the possibility of a fire!
Always connect the battery in the proper order: first connect the (+)
terminal, followed by the (-) terminal. When disconnecting, do the
same in reverse order.
The (+) terminal should have a protective cover to avoid the possibility
of a short-circuit (explosion)!
Avoid sparks and open fire close to the battery.
Make sure that no cables are trapped when working on the machine.
Damage to the cables may cause a short-circuit; this increases the
chance of a fire.
The charging capacity for the battery should be more than 100A. (If
necessary, put the vehicle in a lower gear, so that the engine generates
more revolutions per minute, to ensure that the alternator generates
more power.)
When using an extra battery on the spraying rig, place the voltage
regulating line on the battery of the rig, to ensure that the voltage drop
between the vehicle and the rig is compensated by the voltage
regulator on the alternator.
When in doubt, contact your supplier.
WEED-IT Quadro | User Manual -BT-UMWEEDQ-B 11/ 82