Croplands WEED-IT Quadro User Manual page 60

Sensor order The sequence of the sensors has
changed been altered.
New sensor A new sensor has been detected.
found
60 / 82 | WEED-IT Quadro | User Manual - BT-UMWEEDQ-B
If this occurs after a sensor
replacement, your supplier will
need to confirm this message and
set up the new sensor.
If this problem occurs without
changing the sensors this indicates
a communication problem
between one of the sensors and
the Control unit. Follow the same
procedure as you would in case of
a COM error. The sensor with the
communication issue can be hard
to track down. Browse through the
sensor screens in menu 100 and
check sensor firmware version and
status for any anomalies.
If this occurs after a sensor
replacement, your supplier will
need to confirm this message and
set up the new sensor.
If this problem occurs without
changing the sensors this indicates
a communication problem
between one of the sensors and
the Control unit. Follow the same
procedure as you would in case of
a COM error. The sensor with the
communication issue can be hard
to track down. Browse through the
sensor screens in menu 100 and
check sensor firmware version and
status for any anomalies.