Menu: Fault/Alarm Memory - Siemens SINAMICS DCM Operating Instructions Manual

In the commissioning wizard, the drive is commissioned using the data set selected on
this screen in the AOP column.
The data set selection dialog appears whenever a data set parameter is changed in the
parameter list. The data set selected in the data set selection screen is a default setting.
● Permanent parameter transfer
Parameter changes in the SINAMICS DC MASTER are only made temporarily in the
RAM. If a parameter assignment is intended to be permanent, it is possible to trigger a
save process at this point. Depending on the configuration, this can take from 45 s to
several minutes.
Also refer to Chapter "Operation", Section "Memory card functions".
9.3.4

Menu: Fault/alarm memory

When you select this menu, a screen appears containing an overview of faults and alarms
that are present.
For each drive object, the system indicates whether any faults or alarms are present.
("Fault" or "Alarm" appears next to the relevant drive object).
In the graphic below, you can see that at least one active fault/alarm is present for the
"DC_CTRL" drive object. No faults or alarms are indicated for the other drive two objects.
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
9.3 Controlling via the AOP30 operator panel
Overview of Faults / Alarms
When you navigate to the line with active
alarms/faults and then press the F5 <Diag>
key, the system displays a screen in which
you may select the current or old
alarms/faults.
Operation
353