Siemens SINAMICS DCM Operating Instructions Manual page 479

External measured value / signal state outside of the permissible range
A measured value / signal state read-in via the input area (digital/analog/temperature) has
assumed an impermissible value/state. Identify and check the relevant signal. Check the set
thresholds.
Application / technological function disrupted
The application / technological function has exceeded a (set) limit (position, velocity, torque,
etc.). Identify and check the relevant limit. Check the setpoint specification of the higher-level
controller.
Error in the parameterization/configuration/commissioning procedure
An error was identified in the parameterization or in a commissioning procedure, or the
parameterization does not match the actual device configuration. Determine the exact cause
of the error with the commissioning tool, adapt the parameterization or device configuration.
General drive fault
Group fault, determine the exact cause of the fault with the commissioning tool.
Auxiliary unit faulted
The monitoring of an auxiliary unit (incoming transformer, cooling unit, etc.) has detected an
illegal state. Determine the exact cause of the error and check the relevant device.
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
Descriptions of functions
10.5 Communication via PROFINET IO
477