Protective Conductor Connection And Shield Support - Siemens SINAMICS DCM Operating Instructions Manual

Control module

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Protective conductor connection and shield support

Shield supports are only required if the system is connected to X521/X531.

The bending radii of the cables must be observed (see MOTION-CONNECT description).

Only use screws with a permissible mounting depth of 4-6 mm.

Damage or faulty operation due to incorrect shielding and impermissible cable lengths

If the correct shielding procedures and the permissible cable lengths are not observed, the

machine can be damaged or may malfunction.

• Only use shielded cables.

• Do not exceed the cable lengths stated in the technical data.

SINAMICS DCM Control Module

Operating Instructions, 12/2018, A5E34888669A

Protective conductor connection with M4 screw / 1.8 Nm

Shield connection terminal, Weidmüller company, type: KLBUE CO1, Article number:

Shield support and PE conductor connection

Additional system components

7.3 Sensor Module Cabinet-Mounted SMC30

Sinamics dc master