Additional Components - Siemens SINAMICS DCM Operating Instructions Manual

Description
The electronics (CUD) are available in the following versions:
● Standard CUD
● Advanced CUD (option)
This CUD can be expanded to include a PROFINET module (CBE20) and features
2 DRIVE-CLiQ connections for connecting additional components from the SINAMICS
drive system, as well as a connector for expansion purposes (to include a second CUD).
● Additional (second) CUD (Standard CUD or Advanced CUD) (option)
This additional CUD can be fitted to the right of the first CUD and is used for system-
specific extension of the SINAMICS DC MASTER functions.

Additional components

● Advanced Operator Panel AOP30
The optional Advanced Operator Panel AOP30 is installed outside of the unit – in the
control cabinet door, for example – rather than inside it.
The AOP30 ensures the following additional comfort:
– Commissioning is supported by a wizard.
– Measured values are represented by a graphical operation screen.
– Displays a user-friendly parameter list, including text.
– There are several editors for user-friendly setting and changing of parameters.
– As well as help texts on individual faults and alarms, the fault and alarm messages
– Control of the drive (ON/OFF, setpoint specification, jog, direction of rotation reversal)
– Three LEDs display the drive status.
● Additional module CBE20
The additional module CBE20 is inserted in the optional module slot of an Advanced
CUD. It enables the SINAMICS DC MASTER to access the PROFINET network as a
slave as well as to establish SINAMICS Link connections.
● DRIVE-CLiQ components
The DRIVE-CLiQ interface enables components from the SINAMICS drive system to be
connected.
The following components are supported:
– TM15 (digital inputs/outputs)
– TM31 (digital inputs/outputs, analog inputs/outputs)
– TM150 (temperature sensor inputs)
– SMC10 (resolver evaluation for speed actual value sensing)
– SMC30 (incremental encoder evaluation for actual speed value acquisition)
An SMC10 or SMC30 and up to three TMx modules can be connected to each CUD.
34
which occur are listed.
is enabled "on-site".
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A