Siemens SINAMICS DCM Operating Instructions Manual page 339

Overview of displays and keys
Figure 9-9
Information on the displays
Table 9- 5 Displays
Display
Top left
2 digits
RUN
Top right
2 digits
S
P
C
Bottom 6 digits
The currently displayed
characters flash at 1 Hz
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
Overview of displays and keys
Meaning
The active drive object of the BOP is displayed here.
The displays and key operations always refer to this drive object.
Is displayed, if at least one drive in the drive line-up is in the RUN state (in operation).
RUN is also displayed via bit r0899.2 of the drive.
The following is displayed in this field:
More than 6 digits: Characters that are present but cannot be seen (e.g. "r2" ––>
•
2 characters to the right are invisible, "L1" ––> 1 character to the left is invisible)
Faults: Selects/displays other drives with faults
•
Designation of BICO inputs (bi, ci)
•
Designation of BICO outputs (bo, co)
•
Source object of a BICO interconnection with a drive object different than the active one
•
Is displayed if at least one parameter was changed and the value has not yet been transferred to
the non-volatile memory.
Is displayed if, for a parameter, the value only takes effect after the P key is pressed.
Is displayed if at least one parameter was changed and the calculation for consistent data
management has still not been initiated.
Displays. parameters, indices, faults, and alarms, for example
Saving "RAM to ROM" is active (e.g. initiated by p0977 = 1 or by pressing the P button for a
longer period of time (3 s))
9.2 Parameterizing using the BOP20 (Basic Operator Panel 20)
Operation
337