Activating Function Modules; Activating Offline With Starter - Siemens SINAMICS DCM Operating Instructions Manual

Commissioning

8.6 Activating function modules

8.6 Activating function modules
Subfunctions can be activated in the SINAMICS family drives as function modules.
Through activation, the parameters of the corresponding functionalities are also displayed.
Function modules can be individually activated / deactivated on every drive object.
For SINAMICS DC MASTER, the following subfunctions are modeled as function module.
● Technology controller
● Free function blocks
● PROFINET interface
8.6.1

Activating offline with STARTER

Function modules can be set for all DOs by using the properties dialog (activate by right-
clicking the DO in the project navigator). Example shown for the closed-loop control DO
"Drive_1":
Figure 8-35 Properties
288
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A