Figure 43. Installing the expansion card into a riser
Next steps
1
Install the expansion card
2
If applicable, connect the cables to the expansion card.
3
Install the applicable air
4
Follow the procedure listed in
5
Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card risers
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air
shroud.
4
Disconnect any cables connected to the expansion card.
Steps
1
Using the Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
2
Press the blue release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
82
Installing and removing system components
risers.
shroud.
After working inside your
Safety
instructions.
Before working inside your
system.
system.